vBulletin Mods

i remember there should be a solution to this issue earlier this thread, go search and you'll find it

i did search. and the only reply i found was the one above my last post. so i guess i'll start digging through all the pages.

Found it on like 19, however after step one now i get

Block Disabled:      (Update License Status)
Suspended or Unlicensed Members Cannot View Code.

lol this is also described in a earlier post :) clean your DB for Vbouncer tables, and run the installer again.

The problem is that you all ready have run some of the installation.

I use vBouncer and I'm not satisfied. Its very limited in that it will only inform users who bounce emails from thread subscriptions. That means whenever I send out a mass email, all of those bounces are not caught by vbouncer.

Is it working properly?

that because there have been huge changes within vB since this add was released. But if you just remember to use your "fake" e-mail address when you post, it does work, and collect properly. and then move the users to the banned group

I don't understand what you mean by fake email address.

Have you read the info about this hack and understood have it works?

Yes I do but I don't recall anything requieing me to use a fake email address to post messages.

I have vBulletin running on one server, and my mail server running on another. When I run the diagnostics test, I get PASSED for everything except 'Your IMAP/POP settings can connect.'

As of right now, under IMAP/POP Connection I have '{xxxx.com:110/pop3}INBOX', followed by my username and my password. I have attempted to use my IP Address, mail.xxxx.com and postal.xxxx.com. All of these do not pass the test.

Does anyone have any suggestions?

use this:

Block Disabled:      (Update License Status)
Suspended or Unlicensed Members Cannot View Code.

that should do it :alien:

any one who have fixed this hack?

Thanks! That did the trick.

I have this set up and it appears to be working EXCEPT that it's not moving the users to the new usergroup that I set up for them.

Is this vb 3.6.x compatible ??

Not sure if this will help solve my problem, but here is a screenshot of my settings...

*certain info blocked intentionally.