[magnus]

Reserved.

[Stoebi]

Hi,

where is the file?

[Surviver]

Wow, very nice I'll klick instal if you upload the file :P

[projectego]

Sounds very interesting. I'll also click install once the file has been uploaded.

[magnus]

Durr.. it helps if actually upload the product. Woops!

/embarass

[ZomgStuff]

A lot of potential! Thanks!

Reserved!

[Lionel]

Nice! How does it work? Is it decipharable only by the recipient?

[doogie88]

Thank you very much.
One question though, is there anything that will notify me if it worked or not?
Because I enabled it, the Admin CP options are there, but I tested with a message, and it is just like a normal message.
Thanks.

** okay it seems to be working, because when you 'reply' you see the encrypted message.
However, the one downfall is when you reply, and the original sender gets the original message back, after the receiver read it, the original quoted message is encrypted.
Anyway to fix that?

[magnus]

I'll take a look at it, should be a simple fix.

[magnus]

Ok, updated. Fixed the reply bug, however I did run into an issue with smilies during replies. You may want to check the "disable smilies" when replying for the time being, I'll devise a fix for that tomorrow.

[doogie88]

What do I need to do to upgrade it? Uninstall it and re-install?

[magnus]

You can just install the new version over the old one, just select "Allow Overwrite" on the Product Import page.

[doogie88]

Very buggy, having a lot of problems with it.
Most messages aren't being decrypted.

[magnus]

If you encrypted messages with 1.0, uninstalled, then installed 1.1 -- that would happen. By uninstalling you remove the added 'encrypt' row to the 'pmtext' table. When you re-install, the 'encrypt' row is added but without the correct integer for the previously encrypted messages. So when viewing those earlier encrypted messages, the decryption engine doesn't know to decrypt them.

I've installed, upgraded, uninstalled, reinstalled, reupgraded, etc.. about a dozen times, and each time the encryption/decryption works fine. The only problem, that I'm aware of currently, is occasionally the encryption text will contain a smiley bbcode (ie. ), thus preventing the message from being DEcrypted.

So, until that bug is fixed I would recommend checking "Disable smilies" when sending PM's. Also, keep in mind that this is still Beta, as noted in the original post.

Once I get into my office this morning, I'll go through the code. It was late last night, so God knows.